SEE ANY SPAM? PLEASE REPORT IT, TO KEEP OUR COMMUNITY CLEAN.


Do you have a plumbing business? Is your business plumbing related? Register Now


Author Topic: gas fitting tools  (Read 124 times)

0 Members and 1 Guest are viewing this topic.

Offline roberto

  • Full Member
  • ***
  • Posts: 168
  • Karma: +4/-0
gas fitting tools
« on: July 27, 2018, 08:55:22 PM »
where can i get a very small but long screwdriver for adjusting the flame on a gas hob? i also want to replace my manometer, i would buy a gameco one at $400 but ive seen cheaper ones for $1-200 that only go up to 14kpa but that would do for testing pipework wouldnt it?

Linkback: https://www.plumbers.co.nz/forum/gas-station/11/gas-fitting-tools/2360/

Offline bowtieboy

  • Full Member
  • ***
  • Posts: 244
  • Karma: +30/-0
  • craftsman and proud of it
Re: gas fitting tools
« Reply #1 on: August 01, 2018, 08:34:20 PM »
corys sell very fine long electrical screw drivers that will do the low flame bypass adjustment, i have 2, one i had to grind down the shaft just to do a single job, think it was a classique  from memory.
 i would not recommend gameco manometers, i have had 4 of them and all failed within 2 years, not water proof, dont leave in the sun as the display disappears, basically rubbish.
try a sce digitron 
  :D ;)
I believe in doing a job once and right. !


Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
xx
some aussie tools!

Started by yogi.mandy

7 Replies
4341 Views
Last post February 28, 2012, 09:49:13 PM
by yogi.mandy
xx
Crox Tools

Started by PomGT

2 Replies
1519 Views
Last post December 18, 2012, 08:48:17 AM
by craftsman
xx
Ex-Plumbers Tools 4 Sale

Started by Willis

5 Replies
4337 Views
Last post June 27, 2014, 04:55:46 AM
by Rod Roc
exclamation
Quality Hand tools for sale

Started by Scott Bohm

0 Replies
360 Views
Last post August 24, 2014, 02:48:13 AM
by Scott Bohm
 
Share this topic...
In a forum
(BBCode)
In a site/blog
(HTML)